Mighty Seven DW-404 Manual Del Usuario página 16

BATTERY CHARGING
The battery is supplied partially charged. To
ensure full capacity of the battery, completely
charge the battery in the battery charger
before.
A fully discharged battery pack will charge in
50 minutes for DB-1850P in a surrounding
temperature between 32° F (0° C) and 104° F
(40° C).
1. Charge the Lithium-Ion battery pack with
the correct charger.
2. Connect the charger to a power supply.
3. Align the raised ribs of the battery pack
with the slot in the charger.
4. Slide the battery pack onto the charger.
5. The charger will communicate with the
battery pack to evaluate the condition of
the battery pack.
The tool may be cleaned most effectively
with compressed dry air. Always wear safety
goggles when cleaning tools with compressed
air.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their use.
Use clean clothes to remove dirt, dust, oil,
grease, etc.
BEFORE EACH USE
1. Inspect the Impact Wrench, the on/off
switch and the accessories for damage.
2. Check for damaged, missing, or worn
parts.
3. Check for loose screws, misalignmentor
16
OPERATION
6. The POWER BAR LED lights will cycle
7. After charging is complete, the green
8. The battery pack will fully charge if left on
NOTE: For your convenience, the charger
can operate with most generators and
inverters rated at 300 watts or higher.
MAINTENANCE
4. If abnormal vibration or noise occurs,
5. Detach the battery from the Impact
All of the bearings in this tool are lubricated
with a sufficient amount of high grade
lubricant for the life of the unit under normal
conditions. Therefore, no further lubrication is
required.
from right to left during charging. This is
part of the normal charging operation.
LED on the charger will come on and the
POWER BAR LED lights will go displayed
when the POWER BAR button is pressed
while the battery pack is on the charger.
the charger, but it will not overcharge.
binding of moving parts, or any other
condition that may affect the operation.
turn the tool off immediately and have the
problem corrected before further use.
Wrench before cleaning or performing
any maintenance. Using compressed air
maybe the most effective cleaning method.
Always wear safety goggles when cleaning
tools using compressed air.
LUBRICATION