Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Step 4
Remove the 4 preassembled M6x12 bolts (DD) from
GG
the burner assembly (H)� Attach 3 M8 studs (GG)
FF
and 3 washers (FF) to the burner assembly (H)�
Tighten the M8 studs (GG)�
H
DD
Step 5
WARNING: Remove protective film
JJ
N
before assembling.
Attach the 4 reflector panels (O) to the center
reflector (N) using 12 M6x10 screws (II) and 12 cap
nuts (JJ)� Fully tighten all the screws�
O
II
Step 6
Insert the radiation ring (M) from the top end of the
burner assembly (H) to the support tabs, align the
M
EE
small hole on the radiation ring with the threaded
hole on one support tab and attach it using 1 M4x8
screw (EE)�
H
10
Publicidad
