Princess 01.348235.01.001 Manual De Usuario página 6

Instruction manual
Foot assembly
• If the heater is not mounted on the wall, the supplied feet must be
fitted to the unit.
• Place the feet and secure the item by tighten the screws to the
housing.
• Take care to ensure that the feet are located correctly on the
bottom end of the heater.
Remote control (needs 2xAAA batteries)
• When using the remote control for the first time, please place it
close to the product and long press the on-off button of the
product to match the remote control with the product.
• The built-in temperature sensor of the remote control will send a
signal to the product once a minute. After receiving the signal of
the remote control, the product will display the room temperature.
• If the signal is not received for three consecutive times, it means
that the remote control is out of order or lost. The product displays
the room temperature by its own temperature controller.
• Remote control buttons:
– Power on / off
– Timer
– Dim function (Light of display on/off)
– + / - (temperature up / down)
BEFORE THE FIRST USE
• Put the power cable into the socket. (Note: Make sure the
voltage which is indicated on the device matches the local voltage
before connecting the device. Voltage 220V-240V~ 50/60Hz).
6
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This smell is
only temporary and will soon fade.
• During heating up and cooling down there may be some noises
caused by the heater casing expanding and contracting, this is
normal and does not indicate any fault.
TOUCH BUTTON/DISPLAY FUNCTIONS
USE
• Push the on/off switch on the side of the heater to turn the heater
completely on or off.
Touch button functions
• Press the on/off touch button to turn the heater on, pressing it
again will set the device into stand-by mode.
• Wi-Fi button, when device is on or in stand-by mode:
– Press and hold for 6 seconds to put the heating into paring
mode (will beep 3 times).
– Follow the instructions on your phone.
• Press 'temperature up (+)' or 'temperature down (-)' buttons to
regulate the temperature you desired. The temperature can be
set between 0°C and 37°C. Holding the + or – button will increase
or decrease target temperature continuously.
• Timer button; when the device is on, press the timer button, the
time starts blinking "00:00".
– Use the + and – buttons to set the hours.
– No button press for 5 seconds stops the time blinking.
– Setting time to 00:00 does not enable timer.
– Press timer button again -> time starts blinking and allows the
user to change timer duration.