Husqvarna Z560X Manual De Usuario página 9

the safety devices regularly. If the safety devices are
damaged, speak to your Husqvarna service agent.
• Do not make modifications on safety devices. Do
not use the product if protective plates, protective
covers, safety switches or other protective devices
are not attached or are damaged.
Malfunction indicator light
The malfunction indicator light (MIL) shows the operator
if there is a problem with the engine. Refer to the
operator's manual for the engine.
To engage and disengage the Roll Over Protection
Structure (ROPS)
• Remove the 2 pins that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING:
instructions for the ROPS and the safety
belt.
• Do not use the safety belt if the ROPS is
disengaged.
• Always use the safety belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.
To do a check of the ignition key
• Start and stop the engine to do a check of the
ignition key. Refer to
13 and To stop the engine on page 15 .
• Make sure that the engine starts when you turn the
ignition key to start position.
• Make sure that the engine stops immediately when
you turn the ignition key to stop position.
Operation conditions
These conditions are necessary to start the engine:
• The control levers are in the neutral position.
• The parking brake is applied.
• The drive of the blades is disengaged.
• The OPC is pushed down.
2173 - 002 - 22.08.2023
Obey the following
To start the engine on page
The engine must stop in these situations:
• The parking brake is not applied and the operator
lifts from the seat.
• The drive of the blades is engaged and the operator
lifts from the seat.
Try to start the engine without 1 of the conditions.
Change the conditions and try again. Do this check
daily.
Parking brake
WARNING:
not work, the product can start to move
and cause injury or damage. Make sure that
the parking brake is regularly examined and
adjusted.
Refer to .
Muffler
WARNING:
the muffler is missing or damaged. A muffler
that is damaged or missing increases the
noise level and the risk of fire.
The muffler keeps the noise levels to a minimum and
sends the exhaust fumes away from the operator.
Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
WARNING:
hot during and after use and when the
engine operates at idle speed. Be careful
near flammable materials and/or fumes to
prevent fire.
To do a check of the muffler
• Examine the muffler regularly to make sure that it is
attached correctly and not damaged.
Spark arrestor
This product has an internal-combustion engine. Do not
use the product near vegetation without a spark arrestor
that is approved by local or state laws. Federal laws
apply on federal lands.
A spark arrestor for the muffler is available through your
approved Husqvarna dealer.
Protective covers
Missing or damaged protective covers increase the
risk of injury on moving parts and hot surfaces. Do
a check of the protective covers before you operate
the product. Make sure that the protective covers are
correctly attached and do not have cracks or other
damages. Replace damaged covers.
If the parking brake does
Do not use the product if
The muffler becomes very
9