Publicidad
Idiomas disponibles
Idiomas disponibles
AVG HI / AVG LO
At the top right corner of the display, there are two numerical indicators: AVG HI (2) and AVG LO (3).
As the Zoom Level is changed, the AVG HI and AVG LO will reflect the average high and average low
values on the chart of the selected parameter. At startup, the unit will automatically display values for
1d (day) value.
AUTO DETECT DAY/NIGHT
The built-in photocell sensor can automatically detect whether it is Day or Night. The green back lit
display automatically turns off during the night period. If a button is pressed during this time the green
back light will display for 30 seconds. In Greenhouse (Increase) mode it can override the CO
and shut off the CO
2
during the night. Conversely, if the Photo-Cell detects light and the CO
the CO
generator by turning on the output power (CO
2
In Vent (Decrease) mode, Photo-Cell status does not affect the output power (Exhaust Fan socket) ON
or OFF.
GREENHOUSE (INCREASE) CONTROL
This CO
controller can be set for Greenhouse mode application by S5 ADVANCE Mode
2
setting. CO
2
example, if Set Target Low is 1000ppm, and the Set Target Hi is 1400ppm, the output power
will shut off when CO
VENT (DECREASE) MODE CONTROL
This CO
controller can be set for Vent mode application by S5 ADVANCE Mode setting.
2
Exhaust Fan socket is on when CO
concentration is below Set Target Low.
HOLD HOME
To revert to start-up settings at any point, hold ENTER for 3 seconds until you hear audible beep. The
device will then revert to Home Setting, as if the power was reset, displaying "Back Home done." Note
that this is not the same as Restore to factory settings.
To clear all stored data in the chart you must Restore to factory settings. To use Restore mode select
the Advanced Setting function and hold ENTER for 3 seconds until an audible beep sounds.
Below is a table showing what main menu selection is made by pressing MENU multiple times as well
as their functions. Note that the device will display "Done," followed by the confirmed selection if
selected correctly.
OPERATING INSTRUCTIONS
generator or regulator by turning off the output power (CO
Equipment socket is on when CO
is over 1400ppm and power on when CO
2
EquIpment Socket).
2
concentration is below Set Target Low. For
2
concentration is over Set Target Hi, and off when CO
2
4
Equipment socket)
2
level is low, the device will start
2
is below 1000ppm.
2
control
2
2
Publicidad
