cecotec Conga Rockstar 8500 Infinity Ergowet Animal Turbo Manual De Instrucciones página 42

ENGLISH
When using this product for the first time, make sure the water tank plug is not open.
Mop installation
Place the mop cloth on the ground with the Velcro facing upwards.
Align the mop cloth with the Velcro strips on the water tank and attach it without covering the
wheels.
Replacing the mop
Remove the water tank from the vacuum cleaner.
Use your foot to hold the accessory against the ground and pull the vacuum cleaner upwards
until both parts are separated.
Replace the mop and refill the water tank.
Install the water tank again, insert the tank in the lower part of the vacuuming brush head, and
press until it is fixed.
5. CLEANING AND MAINTENANCE
Always turn off and unplug the vacuum cleaner before cleaning or maintenance.
-
Use a soft, slightly dampened cloth to clean the surface of the appliance.
-
Never immerse the appliance in water or other liquids. Do not allow liquids to enter the
-
appliance.
Do not use abrasive cleaners or scouring pads to clean the device.
-
Do not leave the vacuum cleaner in a place with direct sunlight.
-
- Do not leave the vacuum cleaner in a wet place after cleaning it.
- After the brush has been used for a long time, bristles might start to tangle with hair and
other dirt. Clean the brush to ensure cleaning efficiency.
Cleaning the water tank and the filters
1. Press the dust-tank release button and remove it. Fig. 10
2. Press the dust-tank release button to open the tank cover and empty it. Fig. 11
3. Use the cleaning brush to clean the filter. Fig. 12
4. Hold the dust tank, remove the filter and lift the filter cover to remove the parts inside. Fig.
13
5. Wipe all parts with a slightly damp cloth.
6. After cleaning the filter, press the button on the display for 3 seconds to restart.
Motor filter cleaning. Fig. 14
1. Turn the filter cover counterclockwise to remove it.
2. Remove the filter and clean it.
It is recommended to clean the filter at least every six months.
42