cecotec Conga Rockstar 8500 Infinity Ergowet Animal Turbo Manual De Instrucciones página 43

Cleaning the brush and the vacuum head
1. Press the release tab on the hard floor brush and remove the brush as shown in figure 15.
2. Remove hair and debris around the brush with your fingers or the cleaning brush blade.
3. Wash the brush under running water.
4. Allow the brush to dry completely before reassembly.
5. Replace the brush.
Warning:
The motorised brush includes electrical connections, do not immerse in water for cleaning.
-
Make sure the brush is completely dry before replacing it.
-
Water tank cleaning
To clean the water tank, fill it with clean water, shake it, and empty it.
-
The mop is washable; therefore, it is suggested to wash it after every use.
-
Replace the cloth after 20-30 uses, depending on the use.
-
6. TROUBLESHOOTING
Error codes
Error code
E1
E2
E3
E4
E5
E6
E8
E9
If you notice a problem with the appliance or if it is not working properly, you can carry out a
few simple checks before calling the official Cecotec Technical Support Service.
Problem
The upright
vacuum cleaner
does not turn on
Error description
Battery overvoltage
Undervoltage or significant battery voltage difference.
Undervoltage, overvoltage or overcurrent of the charger
Switch failure, cannot switch on
Thermistor failure
Main motor disconnected or engine failure
Main motor overload
Main motor short circuit
Solution
Before using the appliance, check that it is fully charged.
Check if the appliance is off.
Check whether the filter is correctly positioned or installed.
CONGA ROCKSTAR INFINITY ERGOWET ANIMAL TURBO
ENGLISH
43