Hold Mode - Refco OCTA-WIRELESS Manual De Instrucciones

English
Over Range Indication
If the weight applied to the weighing platform exceeds the maximum capacity of the OCTA-
WIRELESS (100 kg), a single "1" will be shown on the left side of the display. To prevent
damage to the OCTA-WIRELESS, immediately remove the weight from the platform.

Hold Mode

A special feature of the OCTA-WIRELESS allows the emptying or replacing of bins or
containers used for weighing without affecting the weight shown on the display. This Hold
Mode may be used as follows:
1. Allow load to settle until display is steady.
2. Press . The current weight is now locked on the display.
3. Remove, empty, or replace objects, bins, or containers on the platform.
4. Wait 5 seconds for the new load to stabilize.
5. Press . Measurements will continue from where they left off prior to initiating Hold
Mode.
Programming
With the OCTA-WIRELESS, a programmable threshold weight will sound an alarm. The
alarm will sound when the displayed weight (either positive for increasing weight, or
negative for decreasing weight) equals the programmed weight. To program the alarm,
perform the following steps:
1. Set up the OCTA-WIRELESS with the desired units and resolution as described in the
Quick Start Setup section above.
2. If measuring decreasing weight, place the objects or container with the objects or
material that will be removed on the weighing platform.
3. Press to start the SET Mode, indicated by the SET enunciator on the LCD display.
4. Press and/or hold the
set point faster, press
set point 10x faster than normal. Press
mode.
or keys to set the desired alarm set point. To change the
. This will activate the FAST SET mode which will change the
again to return to the normal speed SET
OCTA-WIRELESS User's Guide
9