Battery Installation & Replacement - Refco OCTA-WIRELESS Manual De Instrucciones

English
Stand-by Mode
After shutting off the device, it will remain in stand-by mode for 25 minutes. By pushing
the button during this time the scale can be reactivated without separately turning on
the transmitter.
If no activity happens for 25 minutes, the transmitter shuts off automatically.
Unpacking the OCTA-WIRELESS
1. Remove the OCTA-WIRELESS from the carry bag.
2. Push the signed part of the control box to remove it from the storage dock. The storage
dock is placed on the low side of the weighing platform.
3. Pull out the control box from the storage dock.
4. If desired, extend the mounting hook.
5. Open the battery cover on the transmitter and install the batteries.
Repacking the OCTA-WIRELESS
1. Fold in the mounting hook.
2. Push the control box firmly into the storage dock of the weighing platform until it snaps
into place.
3. Replace the OCTA-WIRELESS into the carry bag.
Battery Installation & Replacement
1. Remove the battery cover by compressing tab at the base of the battery cover.
2. If necessary, remove old set of batteries.
3. Insert 4 'AAA'. Replace battery cover by aligning tabs and snapping back into place.
IMPORTANT: TO PREVENT DAMAGE TO THE OCTA-WIRELESS, CAREFULLY
OBSERVE BATTERY POLARITY AS MARKED INSIDE THE BATTERY COMPARTMENT.
DO NOT LEAVE DEAD BATTERIES INSIDE THE CONTROL BOX. REMOVE
BATTERIES IF THE OCTA-WIRELESS IS NOT TO BE USED FOR AN EXTENDED
PERIOD OF TIME.
OCTA-WIRELESS User's Guide
7