Install The Hrld Sensor; Site Location - Beckman Coulter HIAC 9703+ Manual Del Usuario

Installation
W A R N I N G
Electrical shock hazard. Externally connected equipment must have an
applicable country safety standard assessment.
C A U T I O N
Multiple hazards. Only qualified personnel should conduct the tasks
described in this document.

Site location

Position the instrument on a dry, level surface. The location must be
indoors and near an electrical outlet and a computer. Make sure the
power switch is accessible.
8 English

Install the HRLD sensor

The sensor is held in place by the holding arm. A sampling probe and
tubing must connect to the sensor for sample flow. A cable must connect
to the sensor for signal transmission. To install the sensor, refer to the
illustrated steps.
Note: Do not put Teflon tape on the fitting threads.