Toyotomi Zibro LC-150 Instrucciones De Uso página 8

e - 8
Defective booster.
e - 9 Air filter dirty; or
Fuel pump dirty.
The heater has been in operation
continuously for a period of 50 hours
and has turned itself off automatically.
Out of fuel.
-- : -- +
Too little ventilation.
-- : --
+
Always contact your dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 50 hours continuous operation. The following will then appear
in the display:
the button M (see Section D).
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code cl:05 running back to cl:01. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
H
CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the
heater can only be switched off. Other functions are blocked then. If the heater
has already been switched off, the childproof lock also prevents accidental ignition
of the heater. Activate the childproof lock by pressing the appropriate key N
and holding it down for more than 3 seconds. The KEY-LOCK indicator (
appear on the information display (Fig. H), indicating that the childproof lock has
been activated. Switch off the childproof lock by pressing the key N and holding it
down for more than 3 seconds once again.
I
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature
has dropped again to the set temperature, the heater will automatically switch on
again.
Activate the 'SAVE' setting by pressing the appropriate Q key.
the information display (Fig. I). Switch off the function by pressing the SAVE key
once again.
Without the 'SAVE' setting your heater will maintain the set temperature by
!
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room or
to keep it frost-free.
4
8
. If desired, you can switch the heater on again by pressing
Contact your dealer.
Clean filter
Contact your dealer.
Switch the heater back on.
Refill removable tank.
Ventilate better.
) will
will display on
H: When the mark
appears, the childproof
lock has been activated.
I: When the SAVE
function is activated, the
heater will automatically
switch on or off in
order to remain within
a specified temperature
range.