cecotec MTB Manual De Instrucciones página 75

Step 2
The electric bike is packaged to prevent scratches and damage. Once the box has been
opened, carefully remove the parts of the electric bike. To do this, hold the electric bike by the
stem and top tube and lift it vertically. Place it carefully on the floor, away from the packaging
and in an upright position.
Step 3
Apart from the main body of the electric bike, the box contains smaller boxes containing
other components such as the charger, pedals, and tool kit.
Step 4
The front wheel comes separately with the electric bike, attached with the help of a retaining
clip to the frame. The packaging protects the mechanical brake and the tyre from damage. To
remove the front wheel from the frame, carefully cut off the retaining clip and store it. Next,
be sure to remove the protective packaging from the wheel before you start installing it on
the electric bike.
Step 5
Look for any flanges that may still be left on the wheel. Cut them carefully and make sure not
to damage the electric bike when doing so.
Step 6
Keep the electric bike in an upright position and remove all packaging. Then you can start
assembling the product.
Assembling the handlebar. (Fig. 2)
- The electric bike is delivered with the stem bracket facing away from you. Before
mounting the handlebars, make sure that the stem bracket faces outwards. To do that:
1. First stand at the front of the bike and then loosen the two screws at the handlebar
bracket joint with the 5 mm Allen key.
2. Then carefully turn the stem cover outwards. You must turn the stem cover 180°
counterclockwise and align it correctly.
3. Remove the four screws of the upper bracket with the 4 mm Allen key and remove the
stem cover.
4. Carefully place the handlebars in the now open stem cover. Ensure that all cables are
untangled and exit from the front of the front fork so as not to obstruct movement once
the front wheel is mounted.
5. Align the handlebar slots in the stem. Then replace the stem cover and tighten the
screws clockwise. Make sure that the screws fit into the slot when tightened and that
they are not loose to prevent damage to the thread.
6. Insert the front light and horn wires into the hole at the top of the diagonal tube. Bring
ENGLISH
MTB 75