Toro 51993 Manual Del Operador página 13

Assembly
Connecting the Attachment to the
Upper Shaft
See Figure 2.
To connect the attachment to the upper shaft:
1. Loosen the knob by turning it counterclockwise.
2. Remove the end cap from the attachment shaft.
3. Align the button on the attachment shaft with the guide
recess on the upper shaft.
4. Slide the attachment shaft into the upper shaft until the
attachment shaft clicks into place.
Note: You may need to turn the attachment shaft to
properly align the two shafts.
5. Tighten the knob securely by turning it clockwise.
Guide
Recess
Button
Attachment
Shaft
Removing the Attachment from the
Upper Shaft
See Figure 2.
Follow these steps to remove the attachment from the upper
shaft.
1. Loosen the knob by turning it counterclockwise.
2. Push the button while pulling out the attachment.
Assembly
Upper
Shaft
Knob
Figure 2
Attaching the Front Handle
See Figure 3.
To attach the front handle:
1. Remove the slotted Torx
from the handle support.
2. Press the handle onto the top of the upper shaft, no
less than 10 in. (25.4 cm) from the center of the trigger
handle, angling the handle toward the trigger handle.
3. Place the handle along the upper shaft to a position that
allows for comfortable operation.
4. Place the handle support on the bottom of the tube on the
opposite side of the front handle.
5. Secure the handle with the slotted Torx
Front
Slotted
Handle
Torx
Screw
Handle
Support
screws to separate the handle
™
screws.
™
Trigger
Handle
Barrier Bar
(Model Nos.
51993)
Figure 3
13