Toro 51993 Manual Del Operador página 17

Operation
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields when operating power tools.
Failure to do so could result in objects being
thrown into your eyes resulting in possible seri-
ous injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool.
The use of attachments or accessories not rec-
ommended can result in serious personal injury.
Applications
You may use this tool for the purposes listed below:
 Cutting grass, weeds, and light undergrowth
(all models)
 Edging along sidewalks and driveways (all models)
 Cutting pulpy weeds, vines, and light brush
(Model No. 51993)
Mixing the Fuel
DANGER:
Gasoline is extremely flammable and explosive.
A fire or explosion from gasoline will burn you
and others.
This product is powered by a 2-cycle engine and requires pre-
mixing gasoline and 2-cycle oil. The oil mix should be 50:1,
using oil that meets or exceeds JASO-FC specifications.
Follow these steps to mix the fuel.
1. Obtain a clean container that is approved for use with
gasoline.
2. Mix the 2-cycle engine oil provided with unleaded gaso-
line in the container, according to the instructions on the
oil carton.
Note: This engine is certified to operate on unleaded gaso-
line intended for automotive use with an octane rating of 87
[(R + M) / 2] or higher. Do not use automotive oil or 2-cycle
outboard oil. Store the container out of the reach of children.
Operation
50:1 Gasoline to Oil Mixing Chart
Gasoline Oil
1/2 US gallon 1.3 oz.
1 US gallon 2.6 oz.
2 US gallons 5.2 oz.
1 liter 20 ml
2 liters 40 ml
3 liters 60 ml
4 liters 80 ml
5 liters 100 ml
+ =
Filling the Tank
WARNING:
Always stop the engine before filling the tank.
Never add fuel to a machine with a running or
hot engine. Move at least 30 ft. (9 m) away from
the refueling site before starting the engine. Do
not smoke while filling the tank.
To fill the tank:
1. Clean the surface around the fuel cap to prevent contami-
nation.
2. Loosen the fuel cap by turning it counterclockwise.
3. Pour the fuel mixture carefully into the tank.
4. Clean and inspect the gasket.
Note: Replace the fuel cap if the gasket is damaged.
5. Install the fuel cap and tighten it by turning it clockwise.
WARNING:
Check for fuel leaks. If you find any leaks,
correct the problem before using the product.
6. Wipe spilled fuel from the product.
7. Move at least 30 ft. (9 m) away before starting the
product.
Note: It is normal for the engine to emit smoke during
use.
17