Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning & Maintenance
WARNING! Before cleaning, unplug the power plug first; Do not connect or disconnect the power
plug with wet hands, as there is a risk of electric shock and injury. Do not spill water directly on the
appliance, thus avoiding rust, electricity leakage and accidents.
Internal and external cleaning
Food residues in the interior can cause a bad smell, so it should be cleaned regularly. Infiniton brand
suggests that you clean the interior at least once a month.
Remove all interior elements (shelves, drawers, etc.) and clean with a soft towel or sponge dampened
with warm water. Wipe off dust accumulated on the surface of the appliance frequently.
After using detergent, be sure to rinse it with clean water and then wipe it dry with a cloth.
WARNING! Do not use bristle brushes, wire brushes, detergent, soap powder, alkaline detergent,
benzene, gasoline, acid, hot water and other corrosive or soluble elements to clean the surface of the
appliance, door gasket, plastic decorative parts, etc. to avoid damage. Carefully dry the door seal, clean
the groove with a wooden stick wrapped with cotton thread.
¿What to do if there is a failure in the power supply or cooling system?
•
Try to open the appliance door as little as possible, so that food can be stored safely and freshly for
hours even in summer.
•
If you receive the power cut warning in advance:
1.
Set the thermostat to the highest setting one hour in advance, so that the food is completely frozen
(Do not store new food during this time!). Restore the temperature to the original setting when the
power supply comes back on.
2. You can also make ice in an airtight container and put it inside the appliance to extend the storage
time of fresh food.
Safety checks after maintenance
•
Is the power cord broken or damaged?
•
Is the plug firmly inserted into the socket?
•
Is the socket overheating abnormally?
Note: Electric shock and fire may occur if the power cord and plug are damaged or stained with
dust. If there is any abnormality, unplug the power cord and contact the supplier.
Door seal maintenance
It is easy to damage the door seal if it is soiled by stains such as oil, sauce, etc., so it is best to clean it
carefully.
Replacing the interior light
Uninstall the cover and replace the light with a screw light (E14, 220V / 10W), see pictures below.
Remove the screw of the
thermostat from the display by
about 2 mm with the tool.
Take the other side as the
centre to turn the
lamp to the outside.
29
Pull the lamp in the di-
rection of the arrow.
English
Turn the bulb counterclockwi-
se and remove it.
infiniton.es
Publicidad
