Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
HOW TO OPERATE WITH THE MOWER HOUSING
WARNING: The mulch cover is a safety device. Do not
remove the mulch cover. The side discharge attach-
_[b
ment forces
the discharged
material
toward
the
ground. Always keep the side discharge attachment
in the down position. If the side discharge attachment
is damaged, replace the with an original equipment
part from a Sears Service Center.
IMPORTANT:
When you operate
with the mower housing,
always operate with the throttle control in the FAST position.
1.
Start the engine.
2.
3.
Move the lift lever
to a height
of cut position.
In high or thick
grass, cut the grass in the highest
position
first and then lower
the mower
housing
to a lower position.
CAUTION:
Do not operate with the mower housing in the
LEVEL ADJUSTMENT
position.
If you operate
in the
LEVEL ADJUSTMENT
position, the mower housing and
blades can be damaged.
Move the throttle control to the SLOW position.
4.
Move the attachment
clutch
to the ENGAGE
position.
5.
Push the clutch/brake
pedal completely
forward.
6.
Move the shift lever to one of the speed
settings.
NOTE:
When
you
mow
in heavy
grass
or mow
with
a
bagger,
put the shift lever
in the slowest
speed.
7.
Slowly
release
the clutch/brake
pedal.
8.
Move the throttle
control to the FAST position.
If you need to go
faster
or slower, stop the unit and move the shift lever to another
speed
setting.
9.
Make sure the level of cut is still correct.
After you mow a short
distance,
look at the area that was cut. If the mower
housing
does not cut level, see the instructions
on "How
To Level The
Mower
Housing"
in the Service
And Adjustment
section.
_
ARNING:
For
better
control
of the
unit,
always
select
a safe speed.
HOW TO OPERATE
THE UNIT ON HILLS
_b
WARNING: Do not ride up or down slopes that are too
steep to back straight up. Never ride the unit across
a slope. See the "Slope
Guide" in the back of this
book for information on how to check slopes.
1.
Before you ride up or down a hil!, move the shift lever to the
slowest speed.
2.
Do not stop or change speed settings on a hill. If you must stop,
quickly push the clutch/brake pedal forward and set the parking
brake.
3.
To start again, make sure the shift lever is in the slowest
speed.
Move the throttle
control to the SLOW
position.
Slowly
release
the pedal.
4.
If you must stop or start
on a hill, always
have enough
space
for the unit to roll when you release
the brake and engage
the
clutch.
5.
Be very careful when you change
directions
on a hill. When
on
a slope
or in a turn on a hill, move
the throttle
control
to the
SLOW
position
to help prevent
an accident.
F-040607L
16
Publicidad
