Craftsman 316.792640 Manual Del Operador página 7

iNSTALLiNG THE CUTTING HEAD SHIELD
_ WARNING: To prevent serious persona, injury, never j
operate the unit without the cutting head shield in place.
1. Place the cutting head shield onto the mount bracket. Align the
holes in the cutting head shield with the holes in the mount
bracket. (Fig. 1)
Screw the 2 screws through the mount bracket and into the
cutting head shield until finger tight.
Using a #2 Phillips screwdriver, tighten the screws until the
cutting head shield is firmly in place. Tighten the screws equally.
The gap between the mount bracket and the cutting head shield
should be the same on each side.
2.
3.
Screws (2)
Mount Bracket " hield
Fig. 1