Hinkley AZURA Manual Del Usuario página 11

CEILING CANOPY INSTALLATION
1
Tuck connections neatly into ceiling outlet box.
Remove one screw on bracket and slide the canopy up to
2
mounting bracket and place the key hole on screw on the
mounting bracket, turn canopy until it locks in place at the
narrow section of the key holes.
Align the circular hole on canopy with the remaining hole
3
on the mounting bracket, secure by tightening the two set
screws.
NOTE: Adjust the canopy screws as necessary until the
canopy and trim ring are snug.
Make sure the hook on the hanging bracket properly sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the housing until it drops into place.
INSTALLATION OF THE BLADES
WARNING: To reduce the risk of personal injury, do not bend the
blades while installing, balancing the blades, or cleaning the fan.
Fasten blade to motor with provided blade support plates
1
and screws. Repeat procedure for remaining blades. Make
sure screws are TIGHT! Loose motor screws can contribute
to unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and usually will not
fully compress the lock washers on the motor screws.
Use a large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper alignment
of the blades and noise-free, wobble-free running.
Ceiling Fan
Outlet Box
Hanger Bracket
Canopy
Trim Ring
Fig. 1
WARNING:
Fig. 1
Groove
Screws
Blades
Blade support plates
Screws
| hinkley.com |
©2023 Hinkley Lighting, Inc.
09