Beurer IL30 Instrucciones Para El Uso página 9

4. Initial use
Setup
Remove the unit from the packaging. Remove all packaging material before using the appliance. Before use,
check whether the infrared lamp is properly screwed in. Place the device on flat surfaces. The appliance has an
adjustable lampshade. Set the angle of the fluorescent screen in accordance with your individual requirements.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
Note:
• Ensure that there is a socket near the place where the lamp will stand.
• Lay the mains cable in such a way that no one can trip over it.
5. Operation
1 Switching on the lamp
 Push the plug completely into the mains socket.
2 Enjoying the light
While using the lamp on the face, always keep the eyes closed in order to avoid injury to the eyes (do
not look directly at the infrared light).
The recommended duration of treatment is maximum 12 minutes. We recommend selecting a shorter
radiation period to start with. However, the skin of some people may show an over-sensitive (e.g. with
extreme redness, blistering, itching, heavy sweating) or allergic reaction to heat radiation, even when
the lamp is used correctly.
Additional information
The timer of the IL 30 offers additional comfort. The timer is provided with a sliding switch which
makes it steplessly adjustable up to 12 minutes. The timer can be used as a time stop. In case you do
not want to use the timer function, select the
to the length of use. Prolonged use can damage the skin!
Control elements
Sliding switch
Continuous setting ( )
Off (0)
Length of radiation /min. (maximum 12 min-
utes)
3 Important instructions
The distance between the infrared lamp and the radiated part of the body should not be less than the
following:
IL 30: at least 32 in (80 cm)
Basically,
examine the radiated section of the body regularly. Discontinue radiation immediately if any signs of
an over-sensitive or allergic reaction appear and consult a physician.
4 Switching off the lamp
 Pull the mains plug from the socket.
CAUTION!
The lamp is hot after being used. Let the lamp cool off first long enough before you put it
away and/or pack it up!
Please note that the mains cable must not be wound round the infrared lamp either for storage or
when in use.
6. Changing the infrared lamp
Before every cleaning and when exchanging the infrared lamp, the appliance must be switched off, disconnected
from the mains and must be cool.
Please note that only infrared lamps of the original type may be used as replacements.
setting (continuous setting). In this case, pay attention
9