GE 21 Manual Del Propietario E Instalación página 23

Installation Instructions
BEFORE YOU BEGIN
ROLLERS (CONT.)
To adjust the rollers on 21' mad 23' models:
@
Remo'_e tile base giJlle b) oi)enino_ the (looi_,
removing tile screws at each end, and pulling
it straight out.
Turn tile fl'ont roller _ .......... _ /
a(!iusting screws _[
dockwise to raise the
refrigerah m
cotmterclockwise to
lower it. Use a 3/8"
hex socket
or wi'ench,
OI" _lIl
ad iustable
IvI'ench. " '
@ These models also have rear a(!justable rollei5 so )ou
can align the refrigerator with )our kitchen cabinets,
Use a hmg-handled 5/16" socket wrench to turn tile
screws tot the rear rollei_---clockwise to raise tile
reti_igeratoi; comaterclockwise to lower it.
Replace tile base grille.
DOOR ALIGNMENT
_Mter leveling, make sure that dooi_ are even at tile top.
To make the doors even, at!just the refl_igerator dooi:
Using
a 7/16" socket wrench, turn tile door
a@lsting
screw to the right to raise tile dooi; to tile left to
lower it. (A nflon plug, imbedded in tile threads ot
tile pin, prevents tile pin ti'om turning unless a
wrench is used.)
@ _&J[eI" one or two ttIrns (If tile wI'ench, open }llld
close
tile refi_igerator door and check tile alignment at tile
top of tile dooi3.
Toremove the base '_
grille,openthe doors,
remove the screwat
eachendof the base
grilleandthenpullthe
grillestraightout.
,1
7/16 Socket W rench
_" Raise
23
DIMENSION AND SPECIFICATIONS
(for CustomStyle
TM
models)
O O
._ 7!1/4 "
(178.4 cm)
36"
(91.4cm)
24"
(61cm)
24"
(61cm)
Cabinet
L 3/4" (19mm) A irspace
(1/2"(13mm)Gap +
1/4"(6 mm) W allPlates)
' J'L
25" (63£ cm)
Countertop