GE 18 Manual Del Propietario E Instalación página 19

Installation Instructions
[] PLUG IN THE REFRIGERATOR
__rranoe the coil ot tubing so that it does not _ibrate
2
against the back of the refi'igerator or against the
wall. Push the refl'igerator back to the wall.
START THE ICEMAKER
On power switch models, set the icemaker power
switch to the I (On) position. On feeler arm models,
move the feeler arm to the
ON (down)
position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°C) or below.
It will then begin operation automatically:
in
the ON(down)position
Feelerarmmodel
NOTE: In lower water pressm'e conditions, the
water xalxe may turn on up to 3 times to delixer
enough water to the icemaker.
REVERSING THE DOOR SWING
IMPORTANT NOTES
_hen reversing the door swing:
• Read the instluctions all the way through before
startin *
• Handle parts carefifllv to a_oid scratching, I)aint
• Set screws down b_ their related parts to a',oid usim,,
them in the wrong places.
• Proxide a non-scratching work surtace for
the clooI_.
IMPORTANT: Once you begin, do not moxe the
cabinet tmtil dooi:swing rexersal is completed.
These instructions are fin" chamdng_ , the hinges from
the fight side to the leli side--if you exer want to change
the hinges back to the fight side, follow these same
instructions and rexei_e all references to lett and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment,
TOOLS YOU WILL NEED
Phillipsscrewdriver
Maskingtape
3/8" Head socket driver
(a 6-point socket is
recommended)
Puttyknife or
thin-bladescrewdriver
T2Oor T25Torx ®
driver,whicheveryour
modelrequires
19