cecotec FOLDING Manual De Instrucciones página 81

Assembling the handlebar. Fig. 4
Steps:
1. The electric bike is delivered with the stem bracket facing away from you. Before
mounting the handlebars, make sure that the stem bracket faces outwards. First stand at
the front of the bike and then loosen the two screws at the handlebar bracket joint with
the 5 mm Allen key.
2. Then carefully turn the stem cover outwards. You must turn the stem cover 180°
counterclockwise and align it correctly.
3. Remove the four screws of the upper bracket with the 4 mm Allen key and remove the
stem cover.
4. Carefully place the handlebars in the now open stem cover. Ensure that all cables are
untangled and exit from the front of the front fork so as not to obstruct movement once
the front wheel is mounted.
5. Align the handlebar slots in the stem. Then, replace the stem cover and tighten the
screws clockwise. Make sure that the screws fit into the slot when tightened and that
they are not loose to prevent damage to the thread.
6. Insert the front light and horn wires into the hole at the top of the diagonal tube. Bring the
accelerator cable and the two side brake sensor cables together and join them with the
help of two cable ties.
Assembling the saddle post. Fig. 5
Lift the saddle tube lever and insert the saddle post. Finally, close the lock lever by pressing it
towards the frame. Note: adjust the saddle height with the lever under the saddle.
Assembling the saddle
- For the saddle height pre-adjustment, the saddle should be at the same height as your
hip. Please note that the correct position should be one in which your hip is not tilted to
one side when the pedal is in its bottom position and your foot is fully engaged in the
pedal. Once the pre-adjustment has been made, finally adjust the saddle height, bearing
in mind that when the saddle is raised, the knee should be neither fully stretched nor very
bent when the pedal is at the bottom.
- Adjust the saddle properly to ensure maximum efficiency and comfort during exercise.
The saddle is in the correct position if the user has a slightly bent knee when one of the
pedals is at a 90-degree angle relative to the ground.
- To indicate the maximum height that the saddle can be adjusted, you will see vertical line
markings following the word MIN.
Front wheel mounting. Fig. 6
1. Place the electric bicycle frame upside down on a stable surface. This ensures that no
parts of the electric bike are damaged during assembly. Remove any packaging or zip ties
that may remain on the front wheel.
ENGLISH
FOLDING 81