Assembly Instructions; Installing And Adjusting The D-Handle - Troy-Bilt TB75SS Manual Del Operador

Shaft Grip (4) Screws
Shaft
Housing
On/Off Stop Control
Minimum 6 inches
(15.24 cm)
D-Handle
Bottom Clamp
8

ASSEMBLY INSTRUCTIONS

Fig. 1
Fig. 2
On some units, the D-handle may be preinstalled and
only require loosening the screws and adjusting the
D-handle to the operator. Go to step 4 for adjusting the
D-handle if preinstalled.

INSTALLING AND ADJUSTING THE D-HANDLE

1. Remove the screws and bottom clamp piece that
were installed on the D-handle for shipping.
2. Place D-handle the over the shaft housing and onto
the bottom clamp (Fig. 1). Place it a minimum of 6
inches (15.24 cm) from the end of the shaft grip.
3. Start screws with a large Flat-head or T-20 Torx
screwdriver. Do not tighten until you make the
handle adjustment.
4. If it was preinstalled, loosen the screws on the
D-handle just enough to move the D-handle.
5. While holding the unit in the operating position
(Fig. 2), position the D-handle to the location
that provides you the best grip.
6. Tighten the clamp screws evenly, until the D-handle
is secure.