WolfPack HRH24S Manual De Instrucciones página 61

TROUBLE SHOOTING
Please ensure that you check the following before contacting the service organization:
Symptom
Machine refuses to start
Fluctuating pressure
Machine stops
Fuse blows
Machine pulsating
Cause
Machine not plugged in
Defective socket
Fuse has blown
Defective extension cable
Pump sucking air
Valves dirty, worn out or stuck
Pump seals worn out
Fuse has blown
Incorrect mains voltage
Thermal sensor activated
Nozzle partially blocked
Fuse too small
Air in inlet hose/pump
Inadequate supply of mains
water
Nozzle partially blocked
Water filter blocked
Hose kinked
61
Recommended action
Plug in machine.
Try another socket.
Replace fuse, switch off other
machines.
Try without the extension cable.
Check that hoses and connections
are airtight.
Clean and replace or refer to local
distributor.
Clean and replace or refer to local
distributor.
Replace fuse.Switch off other
machines.
Check that the mains voltage
corresponds to specification on the
model tag.
Leave the washer for 5 minutes to
cool down.
Clean the nozzle.
Change to an installation higher than
the amp. Consumption of the
machine. You may try without the
extension cable.
Allow machine to run with open
trigger until regular working pressure
resumes.
Check that the water supply
corresponds to specifications
required.
Clean the nozzle.
Clean the filter.
Straighten out hose.