Beurer MG 202 Instrucciones De Uso página 13

5. DEVICE DESCRIPTION
The related illustrations are on page 4.
Shiatsu massage seat cover
Back section
1
Rotating massage heads
2
Seating surface
3
Fastening straps
4
Status LED
5
On/Off/intensity button
6
Mains plug
7
6. USAGE
6.1 Positioning the Shiatsu
massage seat cover
1. Position the Shiatsu massage seat cover upright
on a suitable seat with a seating surface and
back rest (chair, sofa or similar). Make sure that
the entire surface of the seating surface
the back section
2. If necessary, use the flexible fastening straps
with hook-and-loop fastener to attach the Shiatsu
massage seat cover.
3. Ensure that the mains cable does not pose a trip
hazard. Insert the mains plug
socket.
6.2 Starting use
 CAUTION
Do not force or jam any part of your body, in par-
ticular your fingers, between the rotating massage
heads or their holders in the device.
2
At first, just press your back carefully
against the Shiatsu massage seat cover.
Then check carefully whether the mas-
sage position is pleasant for you and
then shift your weight gradually towards
the Shiatsu massage seat cover. The
massage should feel pleasant and relax-
ing at all times. If the massage is painful
or uncomfortable, stop the massage or
change your position or the contact pres-
sure.
are in contact with the seat.
1
into a suitable
7
1. Selecting the seat position: Sit comfortably and
upright on the Shiatsu massage seat cover. Take
care to ensure you are positioned in the middle
and that the massage heads
left and right of your spine.
2. Plugging in the device: Insert the mains plug in-
to a suitable socket. The status LED starts flash-
ing green. The device is now in standby mode.
3. Switching on the device: Press the On/Off/in-
tensity button
light up steady green. The rotating massage
heads
2
ing position in the lowest area of the back and
then move up and down in the back section
4. Adjusting the intensity level: The device has
two intensity levels. To switch between the two
intensity levels, press the On/Off/intensity button
during the massage.
6
Status LED
Status LED
5. Switching off the device: To switch the device
off, press and hold the On/Off/intensity button
and
3
for 2 seconds. The status LED
green. The massage heads slowly return to
their starting position. This may take a few
4
seconds depending on the position of the
massage heads. Wait until the massage heads
have reached their starting position. Only then
pull the mains plug out of the socket. Do not
disconnect the Shiatsu massage seat cover from
the power supply while it is in operation. Always
switch off the device first and wait until the mas-
sage heads have reached their starting position.
NOTICE
Use the massager for max. 15 minutes and then
leave it to cool down. Long massages can lead to
over-stimulation of the muscles, creating tension
instead of aiding relaxation. You can end the mas-
sage at any time by pressing the On/Off/intensity
button .
6
13
2
. The status LED
6
travel slowly upwards from the start-
green = low intensity
5
blue = high intensity
5
Maximum application time/auto-
matic switch-off:
As soon as the Shiatsu massage seat
cover is switched on, the automatic
switch-off function will be activated
automatically and preset to 15 min-
utes.
can move to the
starts to
5
.
1
6
starts flashing
5