Publicidad
Idiomas disponibles
Idiomas disponibles
z-
/
""~heunit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
Press one of the function
buttons to select a
source.
If TUNER BAND is pressed, the band cannot be selected in
this step.
Press
TIMER
repeatedly
until
0
appears
on the
display.
When using the remote control, press TIMER while pressing
SHIFT.
Time and audio source name flash alternately.
a
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or Il.
Turning MULTI JOG changes both the hour and the minute.
+
or -
is also available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
duration for the timer-activated
period.
The duration can be set between 5 and 240 minutes in 5
minute steps.
-
or E
iS alSO available instead of MULTI JOG.
5
6
7
Adjust the volume.
The source sound will play at the volume level set in this step
R
when the power is turned on by the timer.
a.
If the volume level is set to 17 or higher, however, it will
j:~j~
;*4JL
automatically be set to 16 when the power is turned on.
, ;;l
%
1?! '+:
Prepare the source.
,.,.
~,., ~' '8'
To
listen to a
CD, load the disc to be played first on tray 1.
;$%;
8
,;""~
To listen to a tape, insert the tape into deck 1 or 2.
'1 ,.
To listen to the radio, tune in to a station.
d
Press POWER to turn off the power.
When the timer-on time is reac:hed~ the unit turns on and
begins play with the selected source.
You can change the source thlat was selected in step 1 by
pressing one of the function buttons before pressing ENTER or
II in step 3.
To check the timer setting
Press TIMER.
The selected source, the timer-cm time, and the duration for the
timer-activated period will be displayed for 4 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel the timer standby mode temporarily
Press TIMER repeatedly so that @ disappears.
To restore the timer standby mode, press again to display ~.
Using the unit while the timsr i:sset
You can use the unit normally after setting the timer.
m
Before turning off the power, carry out step 5 and 6.
m
. Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot Ibeturned on and off by the built
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press either TUNER BAND or VllJEO/AUX to select a source,
then press TIMER repeatedly until ~ REC appears on the
display.
Within 6 seconds, carry out the steps of "SETTING
THE TIMER" from step 3 and insert the tape to be recorded on
into deck 2 after step 6.
m
You cannot use the timer functicm to record from a CD or tape.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or 11 is pressed within 4 seconds after
step 4.
ENGLISH
17
Publicidad
