Publicidad
Idiomas disponibles
Idiomas disponibles
Twist the hand piece to detach it from the grip unit. Twist
the grip piece to detach it from the turnlock fastener. Draw
the grip screw out of the grip piece. Clean the parts thor-
oughly with a brush and detergent. Rinse with water and
let it dry. Do not use aggressive detergent! To connect
the hand piece, follow the above instructions in reverse
order. After connecting, press the grease cup button two
to three times.
4.1.2 r
egrinding the BlAde
The blade can be reground with a com-
mercially available grinding machine.
There are special adapter plates available
for SUHNER blades.
V
ery shArp BlAde
4.1.3 h
Ardening the BlAde
resentative or directly from the manufacturer. Apply the
steel under a light pressure. The last pass should be
along the inside of the blade. When cutting does not im-
prove, the blade must be replaced. Contact the area rep-
resentative or the manufacturer for further information.
O
/ i
utside edge
nside edge
22
!
Exclusively SUHNER steel
must be used. This can be
purchased from the area rep-
There must be an adequate distance between the blade
and the steel.
V
ery shArp BlAde
4.1.4 h
Oning the BlAde
Before honing, clean the hand
piece of all fat and meat residue.
The blade must be honed every day with a knife sharp-
ener or a stone.
With the motor running, hold the flat side of the whetstone
against the flat side of the blade. Move the whetstone
back and forth.
4.1.5 g
reAsing the BlAde
Use only food grade (FDA ap-
proved) lubricants, e.g. TURBO
LUBE
60000078), TURBO LUBE SPRAY (art. no. 60000077).
!
GREASE
(art.
no.
Publicidad
