Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-198-007.book Page 31 Friday, June 10, 2011 9:29 AM
– Press the tool arm in the direction of the fence 18 and saw
through the workpiece applying uniform feed.
– Switch off the machine and wait until the saw blade has
come to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (Sawing Grooves) (see figure N)
The depth stop must be adjusted when a trench gap is to be
sawed.
– Turn the depth stop lever 47 in anticlockwise direction to
the stop (approx. 90°).
– Screw the depth stop 23 completely upward turning in an-
ticlockwise direction.
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner
Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located...
Outer corner
Horizontal mitre angle
Positioning of
workpiece
The finished work-
piece is located...
Bosch Power Tools
– Lower the tool arm by the handle 5 to the desired position.
– Screw the depth stop in clockwise direction until the screw
end touches the lever 47.
– Guide the tool arm slowly upward.
– To obtain the full cutting depth again, turn the depth stop
lever 47 in clockwise direction back to the stop.
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
In addition, the cut can be perfomed with or without slide
movement depending on the width of the profile strip/mould-
ing.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
0°
Left side
Right side
45° left
45° right
Bottom edge on saw
Bottom edge on saw
table
table
... to the left of the
... to the right of the
cut
cut
45° right
45° left
Bottom edge on saw
Bottom edge on saw
table
table
... to the right of the
... to the left of the
cut
cut
English | 31
Lying flat on
the saw table
45°
Left side
Right side
0°
0°
Upper edge against
Bottom edge
the fence
against the fence
... to the left of the
... to the left of the
cut
cut
0°
0°
Bottom edge
Upper edge against
against the fence
the fence
... to the right of the
... to the right of the
cut
cut
1 609 929 X05 | (10.6.11)
Publicidad
