Publicidad
Idiomas disponibles
Idiomas disponibles
7.
The message LOW CURRENT will appear. Turning the control
clockwise will increase the current until reaching the desired
stable value measured on the display or in the bargraph current
indicator.
8.
When the current value is greater than 20% of the nominal value
of the scale, the display will indicate the measured resistance
value.
9.
To finish the measurement press.
EQUIPMENT WITH THE KEY
BEFORE
equipment with the key
Caution: Never connect or disconnect the test leads with the equipment
in operation. If you have to make any changes to the
connection, it must be done with the equipment turned off.
. When you finish all measurements, turn off the
.
15
. DO NOT TURN OFF THE
WITHOUT PRESSING
Publicidad
