Publicidad
Idiomas disponibles
Idiomas disponibles
•
Obstructed back: The brackets block any of the jacks on the back of your TV and
properly you will need spacers when assembling the wall mount.
•
Irregularly shape back: In this type, there is gape between the brackets and surface
of wall mount. You will need spacers when assembling the wall mount.
• Remove the vertical brackets.
Step 2- Select screws, washers, and spacers
1. Select the hardware for your TV (screws, washers, and spacers). A limited number of TVs
come with number of hardware included. (If there are screws that came with the TV, there
are almost always in the holes on the back of the TV). If you don't know the correct length
of the mounting screws your TV requires, test various sizes by hand threading the screws.
2. Select one of the following types of screws:
M4* 12 mm Screw (10)
M4* 30 MM Screw (11)
M5* 12 mm Screw (12)
M5* 30 mm Screw (13)
M6* 12 mm Screw (14)
M6* 30 mm Screw (15)
M8* 16 mm Screw (16)
Use washers for all screws.
For an irregular or obstructed TV back, you can use some spacers.
Caution: use the correct length of screws for installation. If you doubt about installation by
yourself, stop immediately and contact to customer service. Using hardware that is too long
may damage your TV and on the other hand using too short may cause your Tv fall from
the mount and do damage or injuries.
4. Remove the screws for fitting other steps.
5. For flat back TV, directly attaching the vertical brackets to TVs with irregular or obstructed
backs.
Step 3- Option 1: attaching the vertical brackets to TVs with a flat back
1. Align TVs holes on the bracket holes with screws on the back of TV. The brackets must be
level.
2. Place washers M6 16 mm (6) concentric and align on the holes of brackets and then insert
Publicidad
