HP Neverstop Laser MFP 1200 Serie Guía De Referencia página 3

Check toner level
When the toner in the printer runs low, you will need one or two HP Toner Reload Kits to add toner. You can
purchase original HP Toner Reload Kits from www.hp.com/buy/supplies or your local HP reseller.
Check the toner level indicator on the front of the printer to determine when to add toner.
Toner level indicator states
Full:
Toner level is
high and more toner
cannot be added.
Fill:
Toner is partly
depleted. "+1" means
one HP Toner Reload
Kit can be added.
Toner can be added when the Reload Status light
when the light is off. To learn how to add toner, follow the instructions on the HP Toner Reload Kit or download the
User Guide from www.hp.com/support/Neverstop1200.
Troubleshoot wireless setup
As directed in the setup guide, download and install the HP printer software, and follow the instructions in the
software to connect the printer to your wireless network.
When the printer has successfully connected to your wireless network, the Wireless light
panel stops blinking and remains steady blue. If the light does not turn steady blue, try the following solutions.
Problem
The Wireless light
blinking blue and the Wi-Fi
Signal Strength indicator
is not showing on the
display.
The Wireless light
blinking blue and the Wi-Fi
Signal Strength indicator
on the display is
cycling.
The Wireless light
off.
2
Cause/Solution
is The printer is in wireless setup mode and is ready to be configured. Proceed
with software installation and follow the instructions in the software to set up a
wireless connection.
is Wireless connection is in progress. Wait a few seconds for the connection to be
completed. When the connection is complete, the Wireless light
blue and the Wi-Fi Signal Strength indicator
signal strength.
is Wireless connection mode is turned off. Try the following:
Press the Wireless button
turns steady blue, wireless connection mode is on and the wireless connection is
established. You can now print wirelessly.
If the Wireless light
set up. Unplug the USB cable and then press the Wireless button
the Wireless light
software installation and follow the instructions in the software to set up a
wireless connection.
Very Low:
Printer will
not print until toner is
added.
Low:
Toner level is
low. "+2" means two
HP Toner Reload Kits
can be added.
next to the reload port glows white. Toner cannot be added
on the printer control panel. If the Wireless light
blinks amber, a wireless network connection has not been
blinks blue, the printer is in wireless setup mode. Continue
on the printer control
turns steady
stops cycling and indicates the
again. When