Black and Decker HH2455 Manual De Instrucciones página 5

• Reinsert the phillips head screws into the openings on the side of the handle and
tighten securely.
ATTACHING EXTENSION CORD TO TRIMMER
An extension cord retainer is built into
the switch handle that helps prevent the toot from coming unplugged. To use this
feature, first overlap the pigtail cord with the extension cord and tie the two cords in a
knot as shown in figure B. Then, double the extension cord several inches from the
end, and hook the loop formed by doubling the cord over the post in the opening in the
back of the handle area as shown in figure C. Gently tug on the cord to insure that it is
firmly retained in the trimmer's handle.
®
SAVE THESE INSTRUCTIONS FOR FUTURE USE
TO TURN THE TOOL ON
Pull the LOCK BUTTON (4) back with
your thumb and then squeeze the
TRIGGER (5) with your fingers as
shown in figure D. (Once the tool is
running you can release the LOCK
BUTTON.) To turn the tool OFF, release
the TRIGGER.
@
TO LOCK THE TOOL ON FOR CONTINUOUS RUN
WITH THE TOOL RUNNING pull the LOCK BUTTON (4) ALL THE WAYback,
release the TRIGGER (5), then release the LOCK BUTTON. The toot is now locked
ON. To turn the tool OFF, squeeze and release the TRIGGER. NOTE: In order to lock
the toot on, it is important to first release the trigger and then release the lock button.
ROTATING THE REAR HANDLE
The rear handle on the HH2455 has the capability of rotating 180 ° while in use. There
are optional stops at 0 °, 55 ° and 90 ° which are ideal for side cuts and rounded or
irregular shaped shrubs.
To rotate the rear handle, press in on the
pivoting button (6) and turn in the desired
direction as shown in figure E.