Runpotec RM 35 Instrucciones De Uso página 14

ENGLISH
14
GUIDE FOR A MEASUREMENT
1
2
Open the lid of the RM35 with the
install the guide jaws
measured and close the instrument lid. Align cable start fl ush with front housing
surface. Note the index mark (arrow)!
Reset the measured value to 0 (hold RES button
Pull the cable slowly and evenly by hand to the desired length/length to
be measured. Read off the measured value/cut the cable, the front housing
surface is the index mark
Index mark
– Arrow marks front housing surface of the device as measuring
5
reference (start/end point for measurement).
USING THE GUIDE JAWS
Select guide jaws or multi-jaws for the respective cable diameter according to
the tables below. Insert in pairs, with the selected diameter facing up, into the
holes provided.
Ø
Optionally available for square cables
B
All images are representative. Changes and printing errors excepted.
(see Using the guide jaws). Insert the cable to be
2
Cable cross section
Ø 2 – 6 mm
Ø 7 – 12 mm
Ø 13 – 18 mm
Ø 19 – 24 mm
Ø 25 – 32 mm
Cable cross section
Ø 2 – 3 mm
Ø 3 – 4 mm
Ø 4 – 6 mm
Ø 6 – 8 mm
Ø 8 – 10 mm
Ø 10 – 12 mm
Ø 12 – 15 mm
Cable width
2 – 3 mm
3 – 4 mm
4 – 6 mm
6 – 8 mm
8 – 10 mm
10 – 12 mm
12 – 15 mm
locking button on the side. Select and
1
5
down for 3 seconds).
D
Guide jaws
Ø 6 mm – red
Ø 12 mm – grey
Ø 18 mm – grey
Ø 24 mm – red
without guide jaws
Multi-jaws RM35 - Round
Ø 3 mm
Ø 4 mm
Ø 6 mm
Ø 8 mm
Ø 10 mm
Ø 12 mm
Ø 15 mm
Multi-jaw RM35 - Square
Width 3 mm
Width 4 mm
Width 6 mm
Width 8 mm
Width 10 mm
Width 12 mm
Width 15 mm
WWW.RUNPOTEC.COM
5
 
x x
Multi-jaws RM35
Round – for precise
measuring results.
Cable diameter
adjustable by
turning from
Ø 3 - 15 mm.
Multi-jaw RM35
Square – for precise
measurement
results of square
cables, such as
duplex cable, LED
tape, fl at ribbon