YATO YT-99500 Manual De Instrucciones página 10

EN
PRODUCT CHARACTERISTICS
The infrared heater is used to heat rooms. Proper, reliable and safe operation of the product depends on appropriate use, that is
why you should:
Read the entire manual before the fi rst use of the product and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the product, failure to observe the
safety regulations and recommendations of this manual. Use of the product for purposes other than those for which it was intend-
ed shall cause the loss of the user's rights to the warranty and under statutory warranty.
ACCESSORIES
The product is delivered complete but requires assembly or proper adjustment for free-standing models.
GENERAL INSTRUCTIONS FOR USE
The device heats up to a high temperature during use. Be careful when operating the device.
Improper use of the device may result in serious burns and/or fi re.
Do not leave the device unattended when it is connected to a power supply.
Do not use the device for any other purpose than heating rooms, e.g. for defrosting or drying.
It is forbidden to repair, disassemble or modify the device by yourself. All repairs must be
carried out by an authorised service centre.
Children under 3 years of age should be kept away from the device, unless they are under
constant supervision.
Children over 3 years of age and under 8 years of age should only be allowed to switch the
device on and off at the place of the device's operation and if they are supervised or instruct-
ed on how to safely use the device and understand the risks involved. Children over 3 years
of age and under 8 years of age should not connect, clean or carry out maintenance activities
on the device.
The product is not intended for use by people with impaired physical or mental abilities, or by
people without experience in or understanding of the operation of the product, unless they
will be supervised or instructed to use the product safely, in a manner ensuring that the risks
involved are understood. Children should not play with the product.
Keep the device and the power cord out of reach of children under 8 years of age while the
device is connected to the power supply or cooling down.
Recommendations for connecting the device to the power supply
Before connecting the device to the power supply, make sure that the voltage, frequency,
and performance of the supply network correspond to the values shown on the device's rat-
ing plate. The plug must fi t into the socket. It is forbidden to modify the plug or socket in any
manner to make them fi t.
The device must be connected directly to a single power supply socket. The mains supply
circuit shall be equipped with a protective conductor and a protective device of at least 16 A.
When using extension cords, use an extension cord with three wires that can withstand a 16
A current load.
Avoid contact of the power cord with sharp edges, hot objects or surfaces, including those of
O R I G I N A L I N S T R U C T I O N S
10