Publicidad
Idiomas disponibles
Idiomas disponibles
Trouble Shooting
For safety, please observe the following points.
• When trouble occurs, turn the power OFF immediately
and contact your dealer.
If smoke comes out of this unit or a bad odor or strange noise comes out, continuing
to use the unit can cause a fire or electrica! shock. Tum the power OFF immediately,
unplug the power cord from the outlet and contact your dealer.
* Absolutely do not remove the rear cover.
There are parts at high voltage inside, so touching them can cause an electrical
shock. Leave inspection, adjustment and cleaning of the interior to your dealer.
* Do not put anything inside the casing.
if liquid or a foreign object should get inside accidentally, immediately turn the power
OFF, unplug the power cord from the outlet and contact your dealer. Continuing to
use the unit can cause a fire, electrical shock or breakdown of the unit,
If trouble occurs in the display unit, perform the following checks and take the
indicated action; if the trouble persists, please consult with your dealer.
EH
power cord/plug
Plug the power cord into the outlet correctly.
power switch
Press the power switch.
signal cable
Connect the signal cable correctly.
|
|
The power saving function
Release the power saving function by operating the
There is no display
might have acted (if so the pilot | mouse or keyboard.
LED will be yellow).
For additional details please read the Operation
Manual of the hardware you are using.
The mode 1$ not registered.
Perform the desired settings and then save them by
[5]
Г]
waiting 20 seconds or pressing the [1] "Exit" key.
The image is too large
or too small, or it is
displaced from the
correct position.
Is there something that
produces a magnetic field
nearby?
(Examples) Television monitor,
cu
Remove the source of the magnetic field.
Perform degaussing.
Make sure your cable is correct.
Connect the signal connector correctly.
The display color is
abnormal.
(Example) The color is
uneven or off-color.
The image distortion
and or tilt is large.
DI
Characters cannot be
seen clearly; the image
is too dark.
another computer display unit,
speaker, etc.; was the
orientation of the monitor
perhaps changed while it was
in use?
Try a different orientation.
Is the image signal level
correctly adjusted?
Is the brightness or contrast
adjustment turned all the way
down?
Check the video signal level from the computer and
adjust it in the correct direction.
Adjust the brightness and contrast.
€
The screen size and
position do not change.
The front panel keys
fail to operate.
Is the input synchronization
signal within the operating
range?
Are 2 or more buttons being
operated at the same time?
Check the video output mode from the computer,
and select a mode within the display unit operating
range.
For details, please read the Operation Manual of
the hardware you are using.
Operate only one button at a time.
Publicidad
