Panasonic PanaFlat PF70 Manual Del Usuario página 23

UNIMACTM-82D Operating Instructions
UNIMAC™-82D
UPC Code: 0 92281 03121 7
Universal Mac (15 Pin) to VGA Adapter
The Universal Mac (15 Pin) to VGA Adapter allows you to take advantage of the built in video
capabilities of your Macintosh computer with any Panasonic PanaSync™ or PanaSync/Pro™
monitor. You may select via DIP switches one of the available video mode(s) for your monitor
model. The adapter is shipped with the DIP switches set to the 640 x 480 resolution mode.
The Universal Mac (15 Pin) to VGA Adapter has two (2) rows of DIP switches, the A Row and the B
Row, under a cover on one side of the adapter. The DIP Switch Cover is the side opposite the red
label. When the label reads correctly the Mac connector is on top and the VGA monitor connector is
on the bottom. These DIP switches allow you to configure the sync lines coming from the Macintosh
to match up with the VGA sync lines of your Panasonic PanaSync™, PanaSync/pro™ or
PanaMedia™ monitor as required and select one of the resolution(s) that is(are) supported by your
monitor.
The DIP switches also allow the selection of Macintosh extended sense modes to ensure
compatibility with future Macintosh modes and Apple Resolution Switching Software if your
computer and monitor support them.
Installation Procedure
tools recommended: Small common screwdriver with 3/16 inch flat (-) blade.
Step 1 Turn off and unplug from the AC power cords for both the Macintosh computer and the
Panasonic PanaSync'M, PanaSync/Pro'M or PanaMedia™ monitor.
Step 2 Pick up the adapter and locate the DIP switch cover on the side opposite the red label.
Remove the cover over the DIP switches by using one of the two (2) slots on the top or bottom edge
of the cover using a 3/16 inch small common screwdriver or a finger nail. The cover will pop off
easily. Save the cover as it wil! have to be replaced later. Top and bottom refer to the sides of the
adapter that have connectors attached.
Step 3 Using the MONITOR MODE SUPPORT CHART find the monitor & resolution for which you
wish to set the adapter. The chart shows the available modes for Macintosh computers with ail
currently available Panasonic PanaSync™, PanaSync/Pro™ and PanaMedia™ monitors. The DIP-
SWITCH SETTING SELECTION TABLE, indicates the A & B DIP-Switch settings required for
Separate Sync. and On-The-Fly Switching of resolution.
Step 4 Referring to the DIP Switch Setting Selection Chart set both DIP switches (A & B Rows) to
the indicated settings. NOTE: The A Row is toward the Mac (computer) connector (which is wider
and has 2 rows of male pins) end of the adapter and the B Row is toward the VGA (monitor)
connector end (which is the narrower connector with 3 rows of female pins). The DIP switches have
"ON" over switch "1" and there are eight (8) switches in each Row marked "1" through "8". When
you can read the numbers correctly (right side up) the A Row is on top and The B Row is on the .
bottom.
Step 5 After double checking your desired settings, referring to the DIP-Switch FUNCTION TABLE
and the UNIMAC-82D Universal Mac (15 Pin) to VGA Adapter, also see the MONITOR MODE
SUPPORT CHART and check that the resolution and monitor selected from the chart agree with the
adapter dip switch settings. Then replace the cover with "PATENT PENDING" markings on the
inside of the cover facing toward the dip switches away from you, press firmly with your thumb unit it
snaps into place.
—18 —