Publicidad
PASO 44
Version B: Assembling the spool holder: adjusting the nut
Carefully turn the printer so that the side with the side filament sensor is facing
you.
Insert the first M4nEs nut into the front support extrusion (with the orange plastic
cover). Insert the side with the spring (metal plate) first, then push the nut inside.
Insert the second M4nEs nut into the extrusion.
The M4nEs nuts are free to move, you can adjust the position as you want. But
remember, the nut must be slightly pushed in to smoothly move. Anyway, we
recommend approximately the same position as you can see in the picture.
Keep in mind that if you mount the Spool holder too high or too low, it may not fit
the filament spool on it. There has to be enough space around it.
PASO 45
Version B: Assembling the spool holder
Locate pins two pins on the spool-holder-base and line them with the rails in the
spool-holder-slider.
Insert the spool-holder-base into the spool-holder-slider and push it through a little
through the part.
38
3. Instalación de la impresora
Original Prusa XL Doble Cabezal (Ensamblada)
Publicidad
