Publicidad
PASO 46
Version B: Preparing the spool holder
Insert the M4x12 screw on the longer side of the 3mm Allen key.
Insert the 3mm Allen key with the M4x12 screw through the assembled spool
holder to the prepared hole in the spool-holder-base.
The M4x12 screw has to protrude through the spool-holder-base.
PASO 47
Version B: Mounting the spool holder assembly
Attach the spool holder assembly to the M4nEs nut in the extrusion. Note that there
is a protrusion on the spool-holder-mount, which must fit into the groove in the
extrusion.
Tighten the spool holder assembly.
Assemble the second spoolholder and attach it to the lower M4nEs nut with an
M4x12 screw.
Do not use the spool holder as a handle!
3. Instalación de la impresora
Original Prusa XL Doble Cabezal (Ensamblada)
39
Publicidad
