Publicidad
PASO 22
Pin de calibración
PASO 23
Semi-Assembled version only - Checking the Heatbed installation
In this step, we will make sure the Heatbed is installed correctly
Using the T10 screwdriver, slightly loosen all screws on the sides of the bed-frame.
A few turns are enough.
Visit the menu Control > Move Axis and adjust the Move Z value to the lowest
position.
Leave the heatbed for a few seconds until it settles in the lowest position.
While in the lowest position, tighten all screws using the T10 screwdriver.
4. Primer uso
Original Prusa XL Doble Cabezal (Ensamblada)
Inserta el pin de calibración en el
lateral del sensor de filamento.
53
Publicidad
