Axis Communications P55-E Serie Guia De Instalacion página 15

Replace the Dome Cover
Important
This product has a dehumidifying membrane to maintain low humidity levels inside the
dome. To avoid condensation, do not disassemble the camera in rain or in damp conditions.
Note
Be careful not to scratch or damage the dome cover. If possible, keep the protective plastic
on the dome cover until the installation is complete.
Replacing the dome cover is only necessary if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
See Hardware Overview on page 10 for location of components.
1. Loosen the top cover screws and remove the top cover.
2. Remove the dome ring screws and remove the dome ring from the top cover.
3. Attach the dome ring and the replacement dome cover to the top cover and secure by
tightening the screws (torque 1.0 to 1.2 Nm).
4. To install an SD card (not included), see page 15.
5. Put the top cover back in its original position and fasten the screws (torque 2.5 to 3.0
Nm).
Install an SD Card
NO TICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
It is optional to install a standard or high capacity SD card (not included), which can be used for
local recording with removable storage.
See Hardware Overview on page 10 for location of components.
1. Remove the sunshield.
2. Loosen all of the top cover screws and remove the top cover.
3. Insert an SD card (not included) into the SD card slot.
4. Put the top cover back in its original position and fasten the screws (torque 2.5 to 3.0
Nm).
5. Put the sunshield back in its original position and fasten the screws.
AXIS P55–E Series
15