Publicidad
Idiomas disponibles
Idiomas disponibles
Explosion Hazard
Keep flammable
materials and vapors, such as
gasoline,
away from refrigerator.
Failure to do so can result in death, explosion, or fire.
To ensure
proper
ventilation
for
your
refrigerator,
allow
for
a I/2"
(1.25 cm) of
space
on
each
side
and
at the
top.
Allow for a I"
(2.54
cm)
space
behind
the
refrigerator.
If your
refrigerator
has
an
ice
maker,
allow
extra
space
at the
back
for
the
water
line
connections.
When
installing
your
refrigerator
next
to a fixed
wall,
leave
a 2"
(5.08
cm)
minimum
space
between
the
refrigerator
and
wall
to allow
the
door
to swing
open.
NOTE: This
refrigerator
is intended
for
use in a location
where
the
temperature
ranges
from
a minimum
of 55°F
(13°C)
to a
maximum
of
110°F
(43°C).
The
preferred
room
temperature
range
for
optimum
performance,
which
reduces
electricity
usage
and
provides
superior
cooling,
is between
60°F
(15°C)
and
90°F
(32°C).
It is recommended
that
you
do
not
install
the
refrigerator
near
a heat
source,
such
as an
oven
or radiator.
/
1/2" (1.25 cm)
][
2" (5.08
cm)
/
\
Depending
on the width
of your
door opening,
it may be
necessary
to remove
the refrigerator
doors
to move the
refrigerator
into your
home.
IMPORTANT:
If the refrigerator
was previously installed and you are
moving it out of the home, before you begin, turn the
refrigerator
control OFF, and unplug the refrigerator
or
disconnect power. Remove food and any adjustable
door or
utility bins from doors.
Keep the refrigerator
doors closed until you are ready to lift
them free from the cabinet. Provide additional
support for
the refrigerator
door while the hinges are being removed.
Do not depend on the door gasket magnets to hold the door
in place while you are working.
•
All graphics referenced in the following
instructions are
included later in this section after "Final Steps."
5
"
3/_ "
Tools Needed:
_6 , 78 , and 1/4" hex head socket wrenches,
#2 Phillips screwdriver, and a flat-blade
screwdriver.
Remove Doors and Hinges
ElectrJcaJ Shock Hazard
Disconnect
power before removing
doors.
Failure to do so can result in death or electrical
shock.
1. Unplug refrigerator
or disconnect power.
2. Remove the base grille. Grasp the grille firmly and pull it
toward you.
3. Starting with the right-hand
side door, remove the parts for
the top hinge as shown in Top Hinge graphic.
Lift the
refrigerator
door from the bottom
hinge pin.
4. Remove the hinge pin cover from the bottom hinge pin and
keep it for later use. See Bottom Hinge graphic.
5. Remove top hinge cover from left-hand
side refrigerator
door.
6. Remove the parts for the top hinge as shown in Top Hinge
graphic.
Lift the left-hand
side door from the bottom hinge
pin.
NOTE: On some models, remove the hinge pin cover from
the bottom hinge pin and keep it for later use. See Bottom
Hinge graphic.
6
Publicidad
