CAB THUMB32 Manual Del Usuario página 18

4) USER GUIDE
MODALITÀ GRUPPO
and buttons allow you to access the channel mode (transmission of a single code) and the group mode (transmission of
a code group). After selecting the desired mode, select the channel or group with the buttons
ATTIVA CANALE/SU
1sec
Press and hold for 1 sec the increase or decrease button to send the signal.
ATTIVA CANALE/GIU
In channel mode (Ch) you can associate different functions to increase and decrease key for each of the 32 channels available.
In group mode (Gr), select the desired group (from A to F) using the keys
1sec
present in the selected group are transmitted.
COMBINATION OF BLOCK/UNLOCK
ATTIVA GRUPPO/SU
1sec
enabled, if you press any button on the remote control, on display appears the message (Bloc on).
The unlock function is used to avoid pressing keys accidentally or to prevent the device from being used by unauthorized persons.
The above combination is used both to lock and unlock the device.
18
ATTIVA GRUPPO/GIU
ACCESS TO CHANNEL MODE
SEND TRANSMITTER CODE/UP
ATTIVA CANALE/SU
1sec
ATTIVA CANALE/GIU
1sec
ATTIVA GRUPPO/SU
or and type the send signal button. All channels
1sec
If the protective function "Block (Bloc)" is on, you must press
a sequence of buttons on the device (see figure to the side)
ATTIVA GRUPPO/GIU
to access the channel or group mode. The device comes with
the "Block (Bloc)" mode disabled. To activate the function
1sec
use the menu (see SETUP). With the "Block (Bloc)" function
ENG
ACCESS TO GROUP MODE
or .
SEND TRANSMITTER CODE/DOWN