CAB THUMB32 Manual Del Usuario página 21

6.1) SETTING THE RADIO CODE
In standard setup, all channels are set in Rolling-code mode HCS with progressive serial number.
To change the mode of transmission of one or more channels:
1) press the button and hold it down for at least 5 sec to enter the setup menu
2) scroll through the menu using the keys
3) use or buttons to select the number of the channel that you want to change, confirm with the button
4) press the buttons and
FIX: fixed code/programmable, HCS: Rolling code or ARC: (Advanced Rolling-Code).
5) press the button to confirm and save your settings.
The display shows OK to confirm the programming.
6.2) ASSOCIATION OF A CHANNEL WITH A GROUP
Each of the 32 channels can be assigned to one group or more groups available.
To associate a channel with the group proceed as follows.
1) press the button and hold it down for at least 5 sec to enter the setup menu
2) scroll through the menu using the keys
3) press the keys or
4) select the channel to be associated using the
reference group. If the channel is linked, the icon
This operation can be made for each of the 6 groups (from A to F) available.
5) press the button to confirm and save your settings.
The display shows OK to confirm the programming.
Upon first start-up, the device comes with 6 groups (da A ad F) with preset channels which can be changed at any time by
using the above procedure. The following table illustrates the contents of the groups upon the first start-up of the device.
or until reaching the Ch, mode, confirm with the button
to choose the encoding mode:
or until reaching the Gr, confirm with the button
to select the group to change and confirm with the button
or button, type to associate/dissociate the channel with/from the
will be displayed to the side.
ENG 21