Even if the machine is used as required it is still impossible to eliminate certain residual risk
factors totally. The following hazards may arise in connection with the machine´s construction
and design:
Damage to hearing, when sound levels in workshop add up to a total level being harmful.
Wear ear-muffs to eliminate this risk factor.
Respiratory damages due to harmful emissions of wood dust.
Severe cutting injuries at contact with the running band in the uncovered cutting zone.
Injuries (cuts) when changing the band. Wear safety gloves when changing the saw band.
Injury from catapulted workpieces or parts of workpieces.
Injury through breaking saw band
Electrocution through contact with internal leading machine parts
This risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
13
ASSEMBLY
13.1
Initial activities
13.1.1 Delivery content
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
13.1.2 Workplace requirements
The workplace has to fulfill the requirements stated in capture 12.
The ground has to be even, in level and hard. It must be suitable at least to weight it with double
weight per square meter than the machines net weight.
The chosen workplace must have access to a suitable electric supply net hat complies with the
machines requirements.
The machine must be placed in a way that at least 0.8m room free space around the machine.
For longer workpieces sufficient additional place before and behind the machine should be
calculated.
13.1.3 Transport
The machine can be transported in package with a forklift.
The machine is very heavy. The machine shall be lifted from crate with a suitable lifting device
only that is certified to be able to carry the machines load.
The transport and the lifting of the machine shall be performed by
qualified and respectively trained persons only.
13.1.4 Preparation of the surfaces
Uncoated metal machine parts have been insulated with a greasy layer to inhibit corrosion.
This layer has to be removed. You can use standard solvents that do not damage the machine
surface.
Do not use solvents based on nitrite, aggressive solvents like break
cleaners or scrubbing agents!
These damage the machine surface.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
N O T I C E
ASSEMBLY
32
HBS 245HQ