Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART:
See appropriate
section in manual unless directed to Sears service center
CAUSE
1.
Cutting
too much grass/too
fast.
2.
Throttle
in "CHOKE"
position.
3.
Build-up
of grass, leaves
and trash under
mower.
4.
Dirty air filter.
5.
Low oil level/dirty
oil.
6.
Faulty spark
plug.
PROBLEM
Loss of power
Excessive
vibration
7.
Dirty fuel filter.
8.
Stale or dirty fuel.
9.
Water in fuel.
10. Spark
plug wire loose.
11. Dirty engine
air screen/fins.
12. Dirty/clogged
muffler.
13. Loose
or damaged
wiring.
14. Carburetor
out of adjustment.
15. Engine valves out of
adjustment.
1.
Worn, bent or loose blade.
2.
Bent blade
mandrel.
3.
Loose/damaged
part(s).
CORRECTION
1.
Raise cutting
height/reduce
speed.
2.
Adjust
throttle
control.
3.
Clean
underside
of mower
housing.
4.
Clean/replace
air filter.
5.
Check
oil level/change
oil.
6.
Clean
and regap or change
spark plug.
7.
Replace
fuel filter.
8.
Empty fuel tank and refill tank
with fresh, clean gasoline.
9.
Empty
fuel tank and carbure-
tor, refill tank with fresh gas-
oline and replace
fuel filter.
10. Connect
and tighten
spark
plug wire.
11. Clean
engine
air screen/fins.
12. Clean/replace
muffler.
13.Check
all wiring.
14. See "To Adjust
Carburetor"
in Service
and Adjustments
section.
15. Contact
a Sears
or other
qualified
service
center.
1.
Replace
blade.
Tighten
blade bolt.
2.
Contact
a Sears
or other
qualified
service
center.
3. Tighten
loose part(s).
Replace
damaged
parts.
Engine
dies when
1.
Reverse
operation
system
1. Turn ignition
key to
tractor
is shifted
(ROS)
is not "ON" while
ROS "ON" position.
into
reverse
mower
or other attachment
See Operation
section.
is engaged.
1.
1.
Faulty operator-safety
presence
control
system.
Worn, bent or loose blade.
Mower
not level.
Buildup
of grass,
leaves,
and trash under
mower.
Bent blade mandrel.
Engine continues
to run when
operator leaves
seat with attach-
ment clutch
engaged
Poor cut - uneven
Clogged
mower
vent
holes from buildup
of grass,
leaves,
and trash around
mandrels.
,
2.
3.
4.
5.
Check
wiring,
switches
and
connections.
If not corrected,
contact
Sears
or other
qualified
service
center.
1.
Replace
blade.
Tighten
blade bolt.
2.
Level mower.
3.
Clean
underside
of mower
housing.
4.
Contact
a Sears
or other
qualified
service
center.
5.
Clean
around
mandrels
to
open vent holes.
31
Publicidad
