Publicidad
Idiomas disponibles
Idiomas disponibles
6. Removekey from bag and start the
engine (see "TOSTARTENGINE"in
the Operationsectionof this manual).
After
engine
has started,
move throttle
control
to idle position.
7.
Depress
clutch/brake
pedal into full
"BRAKE"
position
and hold. Move
gearshift
lever to 1st gear.
8.
Slowly
release
clutch/brake
pedal and
slowly
drive tractor
off skid.
9.
Apply
brake to stop tractor,
set park-
ing brake and place gearshift
lever in
neutral
position.
10. Turn ignition
key to "STOP"
position.
Continue
with the instructions
that follow.
ASSEMBLE
FRONT
WHEEL
TO
MOWER
1.
Using shoulder
bolt, washer
and
Iocknut from parts bag, assemble
front
wheel to mower
as shown. Tighten
securely.
3.
Remove
plastic
tie securing
belt, bring
belt forward
and check
belt for proper
routing
in all mower
pulley grooves.
NOTE:
Be sure mower
side suspension
arms (A) are pointing
forward
before
slid-
ing mower
under tractor.
4.
Slide mower
under tractor
until it is
centered
under tractor.
5.
FIRST
INSTALL
ANTI-SWAY
BAR (S).
From right side of mower,
insert
ant-
sway bar into hole in transmission
bracket
(T).
INSTALL
MOWER
AND
DRIVE
BELT
See MOWER
AND DRIVE
BELT AS-
SEMBLY
Supplement
Sheet for additional
guidance
on this assembly.
Be sure tractor
is on level surface
and
engage
parking
brake.
1.
Lower
attachment
lift lever to it's lowest
position.
A CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly
and engage
in lowest
position.
2.
Turn steering
wheel
to the left as far as
it will go and position
mower
on right
side of tractor
with deflector
shield
to
the right.
Pivot bar towards
you and insert
other end of bar into hole in rear
mower
bracket
(D). Move mower
as
needed
to insert bar.
Secure
with washer
and retainer
spring
as shown.
9
Publicidad
