Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
MONTAJE Y AJUSTES
Assembling Handle (Fig. A)
Enclosed in the carton are the mower handle parts
(1 upper handlebar pieces, 2 middle handlebar pieces and 1
lower handlebar piece) and hardware package (for contents,
see inside front cover).
1. Lay out the parts of the handle as shown in Figure A
2. Insert the 2 middle handlebar
handlebar
1
3. Fasten the 2 middle handlebars
handlebar
1
piece on both sides with a single handle
bolt, washer, and a wing nut
4. Align the holes of the middle handlebar
holes of the lower handlebar
5. Fasten each side of the two handlebars with handle
bolts, washers, and wingnuts
Fig. A
1
3
4
Attaching The Handle To The Mower
(Fig. B)
1. After assembling the handle, fit the holes at the end of
the lower handlebar
the short metal posts extending out from the side plates
8
of the reel.
2. When the handlebar is in place over the posts, snap
the "E" rings
9
onto the slotted posts on both sides to
prevent the handle from coming off.
Fig. B
9
8
4
2
pieces into the upper
2
to the upper
3
.
2
with the
4
piece.
3
.
2
4
on the left and right side, over
4
NOTE: It can take quiet a bit of pressure to force the second
pin into its proper position. If you are having trouble, set the
entire reel on its side. Apply pressure downward on the lower
handle to position it underneath the short metal posts on the
reel. Gently relieve the pressure until the handle is set into
place upon the second pin.
Assembling Grass Catcher (Fig. C, D,E)
Enclosed in the carton is the grass catcher frame and 2 L
shaped steel tubes
22
.
1. Insert the long end of the L shaped steel tube
downward into the front catcher frame. See Figure C.
Fig. C
2. Snap the formed plastic groove
catcher. See Figure D.
Fig. D
3. Repeat steps 1 and 2 on the opposite side.
22
22
23
over the connected
23
Publicidad
