Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT CHARGING
NOTES
1. Longest life and best performance
can be obtained
if the battery pack is charged
when the air
temperature
is between
60°F and 80°F (16 °- 27°C). DO NOT charge the battery pack in an air
temperature
below +40°F (+4.5°C),
or above +105°F
(+40.5°C).
This is important and will prevent
serious
damage
to the battery
pack.
2. The charger and battery
pack may become warm to touch while charging.
This is a normal
condition,
and does not indicate a problem.
To facilitate
the cooling of the battery pack after use,
avoid placing the charger or battery
pack in a warm environment
such as in a metal shed, or an
uninsulated
trailer.
3. If the battery
pack does not charge
properly:
a. Check current at receptacle
by plugging
in a lamp or other appliance
b. Check to see if receptacle
is connected
to a light switch which turns power off when you turn
out the lights.
c. Move charger and battery
pack to a location
where the surrounding
air temperature
is
approximately
60°F and 80°F (16 °- 27°C).
d. If charging problems persist, take the tool, battery pack and charger to your local service center.
4. The battery pack should
be recharged
when it fails to produce
sufficient
power on jobs which were
easily done previously.
DO NOT CONTINUE
to use under these conditions.
Follow the charging
procedure.
You may also charge a partially
used pack whenever
you desire with no adverse
affect
on the battery
pack.
5. Foreign materials
of a conductive
nature such as, but not limited to, steel wool, aluminum
foil,
or any buildup
of metallic
particles
should be kept away from charger cavities.
Always unplug the
charger from the power supply when there is no battery
pack in the cavity. Unplug charger before
attempting
to clean.
6. Do not freeze
or immerse
charger
in water or any other liquid.
z_WARNING:
SHOCK
HAZARD.
Do not allow any liquid to get inside charger. NEVER ATTEMPT
TO OPEN THE BATTERY
PACK FOR ANY REASON.
tF THE PLASTIC
HOUSING
OF THE BATTERY
PACK BREAKS
OR CRACKS,
RETURN
TO A SERVICE
CENTER FOR RECYCLING.
INSTALLING
/ REMOVING
BATTERY
PACK
z_WARNING:
MAKE CERTAIN
THE LOCK-OFF
BUTTON
IS ENGAGED
TO PREVENT
SWITCH
ACTUATION
BEFORE
REMOVING
OR INSTALLING
BATTERY.
TO INSTALL
BATTERY
PACK:
insert battery pack into tool until fully seated and an audible click is heard (figure A). Make sure battery
pack is fully seated and fully latched into position.
TO REMOVE
BATTERY
PACK:
Depress
the battery
release button in the
O
back of the battery pack and pull battery pack out of tool.
STATE OF CHARGE INDICATOR
The battery is equipped
with a state of charge indicator. This can be used
to display the current level of charge
in the battery during use and during
charging. It does not indicate tool functionality
and is subject to variation
based
on product components,
temperature
and end-user
application.
CHECKING STATE OF CHARGE DURING USE (FIGURE B):
• Press the state of charge
indicator button
(B1).
• The four LEDs (B2) will illuminate indicating the percent
of charge
in the
battery.
See chart in figure
B.
• if LED light does not illuminate, charge
battery.
Publicidad
