Armada Technologies Pro400 Manual De Instrucciones página 13

connect test lead to cable pair to be traced. Then use a tone probe,
which will emit a tone. The volume of the tone will increase the
nearer it is to the cable being traced. Note: The auto off function is
disabled in tone generator mode so that the tone can be injected
into a cable for extended periods while tracing takes place.
4.6 Set Contrast (Level 2)
4.7 Typical Fault Displays
The following diagrams show typical fault traces to assist you in the
identification of faults using the Pro400.
Press to select
press
To escape press .
When tone has been selected,
Press to select
Then press Select
Press to increase or decrease
contrast. Press
13
. To open
.
to return.