Mounting Of Handle; Mounting Of The Blade - Makita EE2650H Manual De Instrucciones

MOUNTING OF HANDLE

CAUTION: Before doing any work on the petrol edger, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
– Make sure that the grip assembly is fitted between the arrow marks (1).

MOUNTING OF THE BLADE

CAUTION: Always wear gloves when handling the cutter blade.
– Turn the receive washer (2) so that the hole on the receive washer aligns with
the hole on the gear case.
– Insert the hex wrench (1) through the holes. Make sure the receive washer
does not turn.
– Holding the hex wrench, turn the nut (5) clockwise with using a socket
wrench.
– Remove the nut and the clamp (4).
– Place the blade (3).
– Return the clamp and the nut.
– Holding the hex wrench, turn the nut counterclockwise to fasten the blade.
– To remove the blade, perform the above steps in reverse.
Note: The cutter blade-fastening nut (with spring washer) wears out in course of
time. If there appears any wear or deformation on the nut, replace it.
(1)
(4)
(5)
9
Engine
(1)
(1)
(2)
(3)